LIM question, coolent passages
09-07-06, 07:59 AM
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: pueblo
Posts: 346
Likes: 0
Received 0 Likes
on
0 Posts
LIM question, coolent passages
ok sence i have had my car apart from doing ratnets, i noticed that on the LIM in the side closer to the front of the car, that passage for coolent is blocked, but the one closer to the firewall is not...... and i wanted to know if somone did this? or if thats just how it should be?
thanks
scot
thanks
scot
09-07-06, 08:58 PM
#5
Lives on the Forum
The stock water cooled turbo used coolant to keep temps in check.
The LIM is machined with only one hole.
Mazda only builds one type of rotor housing.
Since the rotor housings come with those blasted holes on both the front and the back, one of them isn't being used.
Thus, you're left with one hole being "blocked" by design.
-Ted
The LIM is machined with only one hole.
Mazda only builds one type of rotor housing.
Since the rotor housings come with those blasted holes on both the front and the back, one of them isn't being used.
Thus, you're left with one hole being "blocked" by design.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM