Indigo gauge power source
07-20-05, 07:55 PM
#1
Junior Member
Thread Starter
Join Date: Jun 2005
Location: Dallas
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Indigo gauge power source
I am putting in indiglo gauges. I have been following this guide
http://www.fc3s.org/how_tos/appearan...lo_gauges.html
I am to the point of hooking up the 12v + wire. I know which plug i need to be slicing into, but do not know which wire. I can't seem to find it on the wiring diagram from teh FSM either. (I don't have much experince with diagrams like this one) http://www.teamfc3s.org/main/factory...cal_System.pdf. Diagram is on page 23.
Where should i connect this wire????
TIA!!!!
Oh yea, its a 91 N/A coupe.
http://www.fc3s.org/how_tos/appearan...lo_gauges.html
I am to the point of hooking up the 12v + wire. I know which plug i need to be slicing into, but do not know which wire. I can't seem to find it on the wiring diagram from teh FSM either. (I don't have much experince with diagrams like this one) http://www.teamfc3s.org/main/factory...cal_System.pdf. Diagram is on page 23.
Where should i connect this wire????
TIA!!!!
Oh yea, its a 91 N/A coupe.
07-20-05, 09:28 PM
#3
Rotary Enthusiast
Join Date: May 2005
Location: Vernon, BC
Posts: 1,135
Likes: 0
Received 0 Likes
on
0 Posts
check the hjeadlight switch harness... the solid red is constant 12V, which is what I hooked up to, or thje red with black stripe is the parking lights... which might be neat too. only be on with headlights on. its up to you
07-21-05, 07:29 AM
#4
Junior Member
Thread Starter
Join Date: Jun 2005
Location: Dallas
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
The red with black stripe is the one I choose. Its on the bottom row third from teh right just as the How To says. They only come on with the headlights, but so did the other dash lights.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM