I'm Making TID'S FOR 60 dollars with eveyrthing u need
#1
Post count is over rated
Thread Starter
I'm Making TID'S FOR 60 dollars with eveyrthing u need
i have pix i will be making TID mods with included Open air venting off ur factory blow off valve or the option of not getting it if u have an aftermarket BOV i will have pix up soon,
#3
Laying Down Rotary Law
count me in!
I'll need one that doesn't have the stock bov
since i'm installing a fmic
and a aftermarket bov on the piping
I'll need one that doesn't have the stock bov
since i'm installing a fmic
and a aftermarket bov on the piping
Last edited by kabooski; 08-11-01 at 02:49 PM.
#5
I am also interested to see the pics, and possible purchase one. Just a note be sure to run this by Jason or an Admin before we start some sort of group buy on the product, there has been some conflict about such a situation recently.
#6
Post count is over rated
Thread Starter
in that caSe gab my email condolence187@aol.com
Last edited by TurboII RudeBoy; 08-11-01 at 03:20 PM.
Trending Topics
#19
Lives on the Forum
I think he ran away...
I was thinking about restarting to build these things again, but very few people are interested.
Making these things without the emissions fittings is relatively easy to do, but I do have welding capabilities to have them included.
What stopped me was trying to find those spring clamps to include with the kit. I couldn't find anything smaller than 7/8"! I need these spring clamps down to the 1/2" size.
-Ted
I was thinking about restarting to build these things again, but very few people are interested.
Making these things without the emissions fittings is relatively easy to do, but I do have welding capabilities to have them included.
What stopped me was trying to find those spring clamps to include with the kit. I couldn't find anything smaller than 7/8"! I need these spring clamps down to the 1/2" size.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM