hello , to all :-)
have a question ,
drive a rx.7 :-) turbo 2 convertibel . bj 1990 ,with
racingbeat exhaust from motor and other things
now i buy a greddy profec B spez 2 -

how to install - every people i ask , tell me other -
in instruction book i see it not real .
can anybody help here , with picture , maybe



fell free to answer here
or to my e mail account:
rx.7-cabrio@mymail.ch

thank you

heinz
from germany

 

check the greddy website. the instructions are on there to print. i woudl ditch it though, the greddy bc sucks

 

hmm i cant find the link anymore but i know i downloaded it before. this might help thoguh. i realize its the wrong car but install is similar
edit- idk which bc you have but heres for the profec
http://www.wheelsjamaica.com/wheels_...opic=49472.new

 

installation depends if you have a stock turbo (or hybrid turbo) with an internal wastegate or an upgraded turbo with an external wastegate.

 

have the orginal motor , with turbo ,
turbo is ported a littel ,
i have walbro fuel pump ,
and other spark plugs 9 ner and 7 with spark plug wires ,
open airfilter from blitz -
but i think the rb exhaust is the thing -
i buy the boost controller :-)

thanks @Wh1t3 C0m3t and arghx

nice greetings

heinz

 

question that is off topic, but are you from the niedersachsen ?

 

@red sidewinder
no :-)
from nordrhein westfalen - near aachen

 

Quick and dirty instructions:

1) Find somewhere dry to mount the solenoid valve, and also mount it so that the NC (Normally Closed) outlet faces down or to the side, as this will bleed off air from the wastegate.

2) Remove the caps from ALL of the ports, and then attach the two pipe barbs to the COM and NO (Normally Open) ports.

3) Remove the original tubing on the front of the Turbo - there is a T piece in it which goes off to the stock boost solenoid - you need to cap this off - it's not needed.

4) Run a hose from the COM port to the Wastegate actuator - as you look at the turbo from the front, this is underneath and to the left of the turbo.

5) Run a hose from the NO port to the little outlet on the neck of the Turbo compressor - this will be close to the pipe coming vertically off the turbo.

6) Feed the wiring loom for the solenoid valve through the bulkhead and into the drivers footwell.

7) Locate the vacuum pipe that feeds either your Blow off valve or recirc valve, and insert the T piece suppliied with the kit. Run a hose from the free end of this to the small filter (also supplied with the kit) and then another hose through the bulkhead and into the back of the controller.

8) Connect up a 12 supply and the control cable for the solenoid and your ready to go !

9) Start with small values for Gain, Set Gain - and work up from there.

The Manual is here:

http://www.greddy.com/img/PHP/products/pdf/682.pdf

 

thank s @ prof -
that is great -
best wishes from germany to uk -
for many years - i go with my convertibel
to a uk rx7 meeting -
very nice :-)

 

Is that Rotorstock ?

If your coming this year - it's at Santapod in August - come and say hello

I drive a convertible as well - best car I've ever owned