How hard is it to remove....
#1
Senior Member
Thread Starter
Join Date: Nov 2001
Location: Canada, Ontario , Bradford
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
How hard is it to remove....
How hard is it to remove a Turbo and manifold from a 1990 Rx7 turbo.
I was wondering if I could save myself some money by doing it myself but if its to difficult ill just bring it to a shop.
Thanks
Joe
I was wondering if I could save myself some money by doing it myself but if its to difficult ill just bring it to a shop.
Thanks
Joe
#4
Damaged Little F*cker
Join Date: Mar 2001
Location: High Point, North Carolina
Posts: 840
Likes: 0
Received 0 Likes
on
0 Posts
a few hours i think. yes the heatshield is the hardest part. i just cut mine off with a dremel. im not sure what sockets youll need. prolly just a good metric socket set.
#6
Former Rx7 *****
Join Date: Nov 2001
Location: Mississauga
Posts: 4,534
Likes: 0
Received 0 Likes
on
0 Posts
gecko7 if u need help.. give me a shout... i have never done nor do i have an idea how to do it... but hte FSM is god and i'm sure 2 people with an FSM and a telephone will figure it out.
Trending Topics
#9
Former Rx7 *****
Join Date: Nov 2001
Location: Mississauga
Posts: 4,534
Likes: 0
Received 0 Likes
on
0 Posts
gecko... did i mention there is a time limit to my offer... i'm heading back to kingston for 8 months for school again... so u have to let me know before august is over
#10
i beleive u will need a 14mm socket...its tough if u still have the heat shield on, as everyone else has said. the bottom one, i used a wrench to get that off. the two top one, i used the rachet with a 2 inch extension. it also helps if u have small hands...(one of those times when u wished u had girly hands..kekekek).
good luck, ut
good luck, ut
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM