How hard do you think it will be........?
08-23-05, 01:10 AM
#1
Damnit, steel doors hurt!
Thread Starter
Join Date: Apr 2003
Location: Charlotte, NC
Posts: 788
Likes: 0
Received 0 Likes
on
0 Posts
How hard do you think it will be........?
OK i want to rewire my hole car, everthing, but i don't have much there anyways, to start no emisions, no pop up headlights, no ac/heat/air, soon to be no radio, basically anything not need for the car to run and drive on the road
08-23-05, 09:08 AM
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 110 Likes
on
93 Posts
I briefly considered doing the same thing with a generic Painless Wiring harness. But since I still have all the stock climate controls, cluster, lights, etc. it would require a huge amount of effort. Also, I went over all the car's wiring when I bought it, so it has been trouble free. 
However, if yours is siginficantly stripped to the point where most of the stock wiring sits idle, then it might be worth it. However, it is a huge undertaking, and there isn't really any gain unless you are already having wiring problems.
However, if yours is siginficantly stripped to the point where most of the stock wiring sits idle, then it might be worth it. However, it is a huge undertaking, and there isn't really any gain unless you are already having wiring problems.
08-23-05, 09:57 AM
#4
Damnit, steel doors hurt!
Thread Starter
Join Date: Apr 2003
Location: Charlotte, NC
Posts: 788
Likes: 0
Received 0 Likes
on
0 Posts
i don't have wiring probelms that i know off, its just that i got some many wires that just go no where especially under the aluminum dash. I was thinking of a painless kit also.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM