How do you test injectors?
09-27-03, 08:16 PM
#1
Hot Dicken's Cider
Thread Starter
iTrader: (2)
Join Date: May 2003
Location: Marion, Ohio
Posts: 1,428
Likes: 0
Received 0 Likes
on
0 Posts
How do you test injectors?
Injectors dont seem to be working, so i took them out to inspect them. Is there anyway i can test them to see if they are working properly?
09-27-03, 08:19 PM
#2
Super Raterhater
iTrader: (6)
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,629
Likes: 0
Received 2 Likes
on
2 Posts
Remove the upper intake manifold, and pull the fuel rail out of the injector holes but that the injectors are still in the rail, remove the CAS, jumper the fuel pump connector, and turn the key to the 'on position', turn the CAS and it should pulse the injectors and make them fire.
09-27-03, 08:34 PM
#3
Full Member
Join Date: Oct 2002
Location: Milwaukee, WI
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
To test your injector wires just take an ohm meter 2 the leads. Oh, if you have a Noid light kit you can see if the injectors work by hooking them right up, they should flash if the injectors are good.
09-27-03, 08:45 PM
#5
Full Member
Join Date: Oct 2002
Location: Milwaukee, WI
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
that you would need to look up in your owners manual, but remember thats testing the injector clips / wiring. on most cars it reads like 14 ohms from what i've seen, but every car is diff. RX7 guys might kknow more then me :P
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM