Here is a new one(fuel pump cover)
04-12-06, 05:13 PM
#1
C-town Hustler!
Thread Starter
iTrader: (6)
Join Date: Mar 2001
Location: c-town AKA Crofton Md
Posts: 2,721
Likes: 0
Received 0 Likes
on
0 Posts
Here is a new one(fuel pump cover)
Ok,so I changed out my fuel pump and I guess I fucked up and now I have a pin hole in the main line.Right at the bend almost On the damn fuel pump cover.Is there anything out there I can use to take care of this.I have tried,the fuel tank stuff,it would not even stick,cold weld did nothing.Am I just going to have to go to a junk yard and find a replacement piece.Any suggetions please let me know what I can do.
04-12-06, 05:55 PM
#2
if its on the line on the fuel pump cover, take out the assembly, blow the lines good and clean, run some water through them, then blow them dry again...
braze the pinhole
reintsall and chuck a bottle of gasline antifreeze in there....
otherwise find a replacement.......if it were mind I'd just get another one - but brazing should do the trick....
edit: before I get flamed about "bla bla welding, bla bla gas" if you pull the assembly out and do this FAR AWAY from the open gas tank (duh) and clean them out well you will have no issues....common sense is the key here.....
braze the pinhole
reintsall and chuck a bottle of gasline antifreeze in there....
otherwise find a replacement.......if it were mind I'd just get another one - but brazing should do the trick....
edit: before I get flamed about "bla bla welding, bla bla gas" if you pull the assembly out and do this FAR AWAY from the open gas tank (duh) and clean them out well you will have no issues....common sense is the key here.....
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
ChrisRX8PR
Single Turbo RX-7's
21
10-18-15 04:01 PM