Got a ticket for loud exhaust. How to tone down a little
#1
Thread Starter
Rotary Freak
iTrader: (7)
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
Got a ticket for loud exhaust. How to tone down a little
Alright I got a ticket for my so called loud exhaust. I have a three inch downpipe to a HKS muffler. Cops in Philly say my exhaust is fine but Jerzy cops say different.
I was thinking of piping in an additional muffler that is 3in/out that won't cut down on flow like a magnaflow race series or something.
Would that help in keeping the fuzz of my back until I can get the full racing beat system?
The other question is that I have a wideband O2 piped towards the rear of the exhaust. Would it be ok to put in a muffler before that and still be able to get an accurate reading?
I was thinking of piping in an additional muffler that is 3in/out that won't cut down on flow like a magnaflow race series or something.
Would that help in keeping the fuzz of my back until I can get the full racing beat system?
The other question is that I have a wideband O2 piped towards the rear of the exhaust. Would it be ok to put in a muffler before that and still be able to get an accurate reading?
#4
Thread Starter
Rotary Freak
iTrader: (7)
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
Thats if your running the NTK sensor and for only quick tuning sessions. NTK sensors are very expensive.
I'm running PLX-M300 that uses a Bosch sensor and are cheap, but can't take the heat like the NTK sensors and I run it all the time.
I'm running PLX-M300 that uses a Bosch sensor and are cheap, but can't take the heat like the NTK sensors and I run it all the time.
Thread
Thread Starter
Forum
Replies
Last Post