FD to FC intake manifold adapter
#51
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 133 Likes
on
114 Posts
I just ordered the RPM stuff too.I've been waiting on this part to get into production. Under this assumption I collected all the other parts.
This is gonna get done ..again.(been there once,had ECU problems,so I switched back to stock,hunting gremlins).
#56
FC guy
iTrader: (8)
the main reason the FD upper appealed to me was hiding the BAC valve. I had a remote set up mounted on the firewall and the valve stuck so I have had it disconnected ever since
dont know if you were following but I changed the angle of the elbow, I didnt like where it routed the pipe
#57
Trunk Ornament
iTrader: (11)
This appeals to me for the full range TPS
And the BAC being pwm or stepper does matter. I have a standalone too, and it will require different settings to operate if it's a different type. On my standalone, I will have to build a different circuit on the board if it's not a PWM controlled valve (Megasquirt's all about DIY)
And the BAC being pwm or stepper does matter. I have a standalone too, and it will require different settings to operate if it's a different type. On my standalone, I will have to build a different circuit on the board if it's not a PWM controlled valve (Megasquirt's all about DIY)
#58
CLUB13b.com
Join Date: Aug 2011
Location: Kanagawa, JPN / Queensland, AUS
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Hi all I have just done a post CLUB13b with a write up of the REACTION RACING Adaptor.
check it out: CLUB13b 13BT Build: UIM Conversion | CLUB13b: World Wide Rotary Alliance
KANAGAWA REPRESENT!
check it out: CLUB13b 13BT Build: UIM Conversion | CLUB13b: World Wide Rotary Alliance
KANAGAWA REPRESENT!
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM