FD to FC intake manifold adapter
#5
I few US companies made an aluminum adapter (FEED made one in Japan) that made it very simple to bolt an FD upper intake to an S5 lower intake. I'm just trying to help a friend out. The examples of searches have been tried and there is nothing surprisingly that helps me with what I'm looking for. Thanks for your help.
#6
Porsche-Hunter
iTrader: (4)
Join Date: Apr 2004
Location: 90041
Posts: 2,055
Likes: 0
Received 0 Likes
on
0 Posts
follow meeeee.....................https://www.rx7club.com/showthread.php?t=693738
Trending Topics
#14
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 133 Likes
on
114 Posts
Rising RPM is in the process of making one. Check their Facebook page for progress pics: https://www.facebook.com/pages/Risin...0067564?ref=nf
I just ordered rails too.I hope they keep us updated!
#18
Old and In the Way
iTrader: (13)
With hind sight I think that if the adapter was a half an inch thicker that the stock oil fill neck would clear OK. Not sure about hood clearance in that case. My car does not have power steering anymore so plug access is not really an issue.. On my FD I pull the elbow off when I change the oil filter... really not a big deal.
#23
Old and In the Way
iTrader: (13)
So...
Without the adapter you either have to perform surgery on the TB elbow or pull the oil fill tube out of the center iron.
I am hoping for a less drastic solution... bolt on if possible. Maybe the Rising RPM will address this as part of their project.
The engine is a fresh Mazda reman and I am hesitant to try and pry out the fill tube on the assembled engine..
Without the adapter you either have to perform surgery on the TB elbow or pull the oil fill tube out of the center iron.
I am hoping for a less drastic solution... bolt on if possible. Maybe the Rising RPM will address this as part of their project.
The engine is a fresh Mazda reman and I am hesitant to try and pry out the fill tube on the assembled engine..
#25
FC guy
iTrader: (8)
thanks but its in rough shape in that picture, I am in the middle of set ups and those pics were just for mockup, I am doing something to my manifolds and pipes that i dont believe anyone has done yet as far as appearance goes
The ac doesnt quite operate 100% yet, its a frankenstein of components of s4 ac delete bracket and FD compressor with tensioner and custom lines. Dont think we have the pressure right yet.
swilson- without the adapter you have to port the uim and lim, the elbow is a different issue regardless of the adapter or porting
here is the porting
The ac doesnt quite operate 100% yet, its a frankenstein of components of s4 ac delete bracket and FD compressor with tensioner and custom lines. Dont think we have the pressure right yet.
swilson- without the adapter you have to port the uim and lim, the elbow is a different issue regardless of the adapter or porting
here is the porting