FC hard to start and door light stopped working, please help!!
#1
Junior Member
Thread Starter
Join Date: Aug 2006
Location: South Wales
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
FC hard to start and door light stopped working, please help!!
My FC is really hard to start everytime, could someone advise me whee to look at?
Also my door light, has stopped working but i have checked the fuses, and it looks fine. Please advise me where to check????? Thank you so much!!!!!!
Also my door light, has stopped working but i have checked the fuses, and it looks fine. Please advise me where to check????? Thank you so much!!!!!!
#2
Rotary enthusiast
Join Date: Mar 2006
Location: Connecticut
Posts: 664
Likes: 0
Received 0 Likes
on
0 Posts
youre running low on headlight fluid, you need a new engine
but seriously, try taking hte door sensor (little rubber thing) off and sanding the contact points clean
works like a charm
but seriously, try taking hte door sensor (little rubber thing) off and sanding the contact points clean
works like a charm
#3
so's mine, but then again, it is 18 years old, I have removed a number of parts (aws, air pump etc, and my tps is bad). Its hard to start because fcs push a tad much fuel when starting (why its so easy to flood one.). Do a full tune up, that should at least help some. Check the oil (I have found that when the oil level gets low, it tends to get hard to start. which is why youo should check the oil every tim you gas up). Much of this material has been covered. Please do a search, and you will find out more. How long have you had the car?
#4
Junior Member
Thread Starter
Join Date: Aug 2006
Location: South Wales
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
I had the car only a few days, and i am having hard time to start the car, it starts but somtimes it takes a few cranks and sometimes it takes 20 minutes to start.
I am so new to rotary, so i don;t know where to check the faults? My FC is 88 model, shall i replace the spark plugs? Spark Wires? or any other recommendations??
Many thanks
I am so new to rotary, so i don;t know where to check the faults? My FC is 88 model, shall i replace the spark plugs? Spark Wires? or any other recommendations??
Many thanks
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM