Crank angle sensor
03-31-05, 10:14 PM
#1
Rotorheads unite!
Thread Starter
Join Date: Mar 2005
Location: Bruce County, On.
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
Crank angle sensor
Two quick questions:
-> Could a faulty Crank Angle Sensor create a no spark or no start situation?
-> My fuel pump is toast, gas tank is toast...I wanna put some gas in the rotary housing to see if it will at least fire for 1 - 2 seconds...does this/could this work?
-> Could a faulty Crank Angle Sensor create a no spark or no start situation?
-> My fuel pump is toast, gas tank is toast...I wanna put some gas in the rotary housing to see if it will at least fire for 1 - 2 seconds...does this/could this work?
03-31-05, 10:55 PM
#3
Rotorheads unite!
Thread Starter
Join Date: Mar 2005
Location: Bruce County, On.
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
Follow up question:
Your supposed to be able to test the crank angle sensor with an ohm meter..they should range between 115 Ohms - 230 Ohms... the plug for the CAS would be disconnected so I would have to test it while the engine is turning over..
Your supposed to be able to test the crank angle sensor with an ohm meter..they should range between 115 Ohms - 230 Ohms... the plug for the CAS would be disconnected so I would have to test it while the engine is turning over..
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM