clutch install on 89 gxl
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Aug 2001
Location: houston
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
clutch install on 89 gxl
i installed the clutch yesterday because a small bering broken any how after i got it all back in . i went to drive it and it takes all gears fine , the problem lies on once in the gear if i give gas slow the car move as normal bot if i try to go over 3-4k rpm on any gear on hard acceleration the clutch slips any ideas?????
#2
Driving RX7's since 1979
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 9 Likes
on
9 Posts
Either your clutch isn't fully engaging, or your accidentally got lubricant on the clutch face. Either way, only way you can determine and correct is to take it apart. If you had it done, take it back NOW!!!!
Long shot, I had a problem with cooling fluid dripping from the back of my Dynamic Air Chamber. At the same time, I was having a similar problem. When I replaced the Chamber with a good used one, the slipping went away. Coincidence??
Long shot, I had a problem with cooling fluid dripping from the back of my Dynamic Air Chamber. At the same time, I was having a similar problem. When I replaced the Chamber with a good used one, the slipping went away. Coincidence??
#5
Senior Member
Join Date: Apr 2001
Location: Dublin, VA
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
Clutch disk installed the wrong way. Seems like I checked once and it wouldn't fit.
Pressure plate bolts not tight.
Trans not fully mated to the engine. (small gap between engine and trans).
Throwout bearing not fully releasing.
Previously mentioned fluid on the clutch.
Could be lots of things.
What parts are new which parts are old?
Pressure plate bolts not tight.
Trans not fully mated to the engine. (small gap between engine and trans).
Throwout bearing not fully releasing.
Previously mentioned fluid on the clutch.
Could be lots of things.
What parts are new which parts are old?
#7
Banned. I got OWNED!!!
Im assuming the pressure plate is good and tight. You probably just got the disc wet or greasy, and it will wear off. IT is possible your pressure plate is defective, and not clamping fully, but if its new this is unlikely. If it doesnt fix itself in a few days(oil on disc wearing off) then you should probably take it back apart and exchange your parts again, mainly the pressure plate.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Rotary Car Performance
4
10-28-20 11:01 AM