Can we save it!
#1
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
Can we save it!
well heres the downlow
two weeks ago someone stole my gas cap....yes you read correctly.
now being cheap i put some serran wrap on the hole and winged it only to find out a week later, after days of heavy rain, that my car wont start.
the starter goes on forever. took out the fuel line and put it in a bottle to see if there is any gas flow there isnt. so i look at where the seran wrap is and its not there anymore and the rim of the filler neck is wet.....with water i havent had the time to take the fuel pump out but i assume is rusted to hell if this is the end result is there any saving it and if not is there anywhere i can buy the pump alone and not the whole set up
ie. mazdatrix $299.00 :[ ] what??
i know hot to do the whole install but i just dont trust these autopartswarehouse.com ect., and i really want a new one which are scarse if not non existant in puerto rico...trust me ive looked...
p.s i never found out where my ecu is. i need to switch it for a resolderd one.
thanks
two weeks ago someone stole my gas cap....yes you read correctly.
now being cheap i put some serran wrap on the hole and winged it only to find out a week later, after days of heavy rain, that my car wont start.
the starter goes on forever. took out the fuel line and put it in a bottle to see if there is any gas flow there isnt. so i look at where the seran wrap is and its not there anymore and the rim of the filler neck is wet.....with water i havent had the time to take the fuel pump out but i assume is rusted to hell if this is the end result is there any saving it and if not is there anywhere i can buy the pump alone and not the whole set up
ie. mazdatrix $299.00 :[ ] what??
i know hot to do the whole install but i just dont trust these autopartswarehouse.com ect., and i really want a new one which are scarse if not non existant in puerto rico...trust me ive looked...
p.s i never found out where my ecu is. i need to switch it for a resolderd one.
thanks
#3
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
lmao you laugh but do you know where it is? i know its sopposed to be somewhere on the passenger side but its not there
Last edited by Roto_Racing; 07-30-10 at 03:54 PM.
#9
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
i just thought of pulling the rug up and its on the firewall under the rug and its sorroundings are kinda rusted still want to know if the pump is rebuildable or if anyone knows where to get the pump alone and not just the whole thing
#11
Retired Moderator, RIP
![](https://www.rx7club.com/images/misc/10_year_icon.png)
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
..FC RX7???Ok.the ECU is located under the passenger side Carpet,.you have to remove the Door Scuff panel,the Side Kick panel and pull the rubber door trim off a touch,at the area around the Hinges and the Bottom corner.
Put the seat all the way back and pull the carpet from Up under the dash,The Ecu is behind a Protective plate on the slanted part of the floor.
NOW,the Fuel Pump,assuming it is an FC we are taling about.
Undo the Spare tire HInges( the plastic Tab things riht above the little vents that are Built IN to the carpetting in the Rear).
pull the capet UP.
pull the black rubberized mat on the rear Hatch floor Off and Out.
you should see a Silver Plate on the Driver's Rear of the car with 4 Phillips head screws(star shaped heads!)
undo those screws and it allows you to access the top of the Fuel Tank.
The Pump and sender assembly is held on the tank by 8 Phillips Screws which can be Tough to get off.you have to also Undo the Feed and Return line and disconnect the Fuel Power Conmnector too,in order to get the Sender/Pump assembly out(Disconnect Battery when working on Electrical!)
.If you do not know this,there is a 14mm nut on teh Passenger side of the gas tank at the Bottom,and it is a DRAIN plug.you should be able to Drain Fuel from there.
Honestly I wuld just drain the Fuel<flush with GOOD gas and drain,then Use the Pump to Pump Fuel to the Engine(where you would have disconnected the LINE IN to the engne) let the pump Clear the bad fuel OUT,.
Replace teh Fuel Filter as it is now Contaminated with water.
OH<>.and Get a Freakin Gas Cap!
Good luck,.STYX.
Put the seat all the way back and pull the carpet from Up under the dash,The Ecu is behind a Protective plate on the slanted part of the floor.
NOW,the Fuel Pump,assuming it is an FC we are taling about.
Undo the Spare tire HInges( the plastic Tab things riht above the little vents that are Built IN to the carpetting in the Rear).
pull the capet UP.
pull the black rubberized mat on the rear Hatch floor Off and Out.
you should see a Silver Plate on the Driver's Rear of the car with 4 Phillips head screws(star shaped heads!)
undo those screws and it allows you to access the top of the Fuel Tank.
The Pump and sender assembly is held on the tank by 8 Phillips Screws which can be Tough to get off.you have to also Undo the Feed and Return line and disconnect the Fuel Power Conmnector too,in order to get the Sender/Pump assembly out(Disconnect Battery when working on Electrical!)
.If you do not know this,there is a 14mm nut on teh Passenger side of the gas tank at the Bottom,and it is a DRAIN plug.you should be able to Drain Fuel from there.
Honestly I wuld just drain the Fuel<flush with GOOD gas and drain,then Use the Pump to Pump Fuel to the Engine(where you would have disconnected the LINE IN to the engne) let the pump Clear the bad fuel OUT,.
Replace teh Fuel Filter as it is now Contaminated with water.
OH<>.and Get a Freakin Gas Cap!
Good luck,.STYX.
#12
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
i know all this i just figured out the ecu i always thought it was under the dash . ive taken out my fuel pump plenty of times but htanks for the step by step, yes i drained it out already but rather than use the plug i dropped the tank to clean out the rust on the inside.
yes unfourtunately i did buy the gas cap a bit late ( one week i kinda had to wait to get paid you know getting paid minimum wage and what not). well my pump is rusted to hell on the outside i cleaned it up and it looks to be only surface rust . i'm gonna try to bench test it, but if the test fails i need to know where i can buy the pump alone not the whole pump with brackets and fuel level. thanks for all the imput guys i really want to get the fc back on the road i finally got all the mechanical issues buffed out and i do something stupid like this.
yes unfourtunately i did buy the gas cap a bit late ( one week i kinda had to wait to get paid you know getting paid minimum wage and what not). well my pump is rusted to hell on the outside i cleaned it up and it looks to be only surface rust . i'm gonna try to bench test it, but if the test fails i need to know where i can buy the pump alone not the whole pump with brackets and fuel level. thanks for all the imput guys i really want to get the fc back on the road i finally got all the mechanical issues buffed out and i do something stupid like this.
#13
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
okay just got the tank back in and the f/p cleaned when i benched tester it it seemed to work it made a buzzing sound and threw out the gas i had in a bowl but when i put it back in started the car it worked but about a minut later it failed gonna keep working on it but if you have any tips i got the laptop right next to the car
and im going to buy from autopartwarehouse.com any objections please dont hesitate
and im going to buy from autopartwarehouse.com any objections please dont hesitate
#16
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
okey got the pump back outand its whining is less loud then when i first tested it what could this be
i want the car now and i dont know when im gonna get paid i guess i will have to wait if anyone knows a way to take apart the pump well im still gonna go figure it out now but any help is useful ;?
i want the car now and i dont know when im gonna get paid i guess i will have to wait if anyone knows a way to take apart the pump well im still gonna go figure it out now but any help is useful ;?
Last edited by Roto_Racing; 07-31-10 at 03:00 PM.
#17
Senior Member
![](https://www.rx7club.com/images/misc/10_year_icon.png)
Join Date: Aug 2005
Location: Onanole, Manitoba Canada
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
Did you replace the low-pressure fuel filter, the "sock"? White plastic square screen box, at bottom of fuel pump.
I replaced mine, it was clogged, but did not look like it. Job #1 when in with the fuel pump.
Mike
I replaced mine, it was clogged, but did not look like it. Job #1 when in with the fuel pump.
Mike
#19
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
just tested it the pump makes a little sound like a electric motor is working inside so at least i know that the pump works tomorrow put the tank back in and test it wish me luck!
#23
Roto Racing Development
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Location: puerto Rico
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
thank you i had a feeling about the walbro well anyway i think i got the pump working if the car doesnt staart tomorrow its gotta be something else
can i get a new one in the forum though?
and are these websites that sell auto parts legit
can i get a new one in the forum though?
and are these websites that sell auto parts legit
#24
You should test the fuel pressure if you got the pump working. Tee into the fuel line with a fuel pressure gauge. If you need a new pump then place a want to buy ad in the parts section of this forum. I bet you can get a good condition stock n/a pump for like $25 shipped.