Can I put a '84 13B into my '88?
09-03-03, 08:09 PM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2003
Location: Mississauga, ON
Posts: 661
Likes: 0
Received 0 Likes
on
0 Posts
Can I put a '84 13B into my '88?
hi everyone!!
i have a '88 NA w/ a blown motor, and found someone around my area selling a 13b from '84. i was wondering if you guys can give me a hand and tell me:
1) if it is going to be a straight swap.
2) if the 13b from '84 and '88 are the same (do they make the same power?)
that's all. thanks so much guys!!
howi
i have a '88 NA w/ a blown motor, and found someone around my area selling a 13b from '84. i was wondering if you guys can give me a hand and tell me:
1) if it is going to be a straight swap.
2) if the 13b from '84 and '88 are the same (do they make the same power?)
that's all. thanks so much guys!!
howi
09-03-03, 08:37 PM
#3
Rotorhead
Join Date: Feb 2001
Location: Charlottesville, Virginia, USA
Posts: 9,136
Likes: 0
Received 39 Likes
on
33 Posts
Re: Can I put a '84 13B into my '88?
If you just look at the two engines you can see that they are a little different. For fitting purposes, the 1Gen 13B has a different oil pan, but I'm not sure what else will be an issue. It is very uncommon to put a 1Gen 13B into a 2Gen car, but quite a lot of 1Gen owners put 2Gen 13B engines in their cars. I suggest posting in the 1Gen section to find out the differences that matter. You would need to reverse-engineer what they say, but I think you will get the best practical knowledge by asking them.
Thread
Thread Starter
Forum
Replies
Last Post
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM
KAL797
Test Area 51
0
08-11-15 03:47 PM
