Can anyone tell me by steps on how to remove and replace the pulsation damper on a s5
07-14-06, 12:45 PM
#2
Former Moderator. RIP Icemark.
On a S5 you replace the whole primary fuel rail. The S5 PD is welded onto the end of teh fuel rail.
Instructions for accessing the fuel rails can be found in the FSM. FSM links can be found in the FAQ for FC sticky thread, found at the top of this, the 2nd gen RX-7 technical section
Instructions for accessing the fuel rails can be found in the FSM. FSM links can be found in the FAQ for FC sticky thread, found at the top of this, the 2nd gen RX-7 technical section
07-16-06, 10:31 PM
#4
Can anyone tell me by steps on how to remove and replace the pulsation damper on a s5
Can anyone tell me by steps on how to remove and replace the pulsation damper on a s5 want to remove the pulsation damper
what do i need to buy to do this i mean parts
thanks really appreciate it
what do i need to buy to do this i mean parts
thanks really appreciate it
07-16-06, 10:52 PM
#7
Step one, remove old fuel rail.
Step two, buy NEW fuel rail.
Step three, install new fuel rail.
S5' have teh FPD welded into the rail itself. So yoru best bet is to either buy a whole new rail or get a s4 rail and use it(though im not 100% sure if its a direct swap.)
Step two, buy NEW fuel rail.
Step three, install new fuel rail.
S5' have teh FPD welded into the rail itself. So yoru best bet is to either buy a whole new rail or get a s4 rail and use it(though im not 100% sure if its a direct swap.)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM