BridgePort
#1
Full Member
Thread Starter
Join Date: Mar 2002
Location: California
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
BridgePort
I just pulled a 90 N/a out of a junk yard yesterday to go in my 91. Going to check out the damage today after work. I am lookin to rebuild it and maybe bp - Anyone know where I can get a fuel map for an S-AFC, and which sites to get a template off of? Maybe soul assasin?
Oh and I'm open to encouragement and discouragement!
Oh and I'm open to encouragement and discouragement!
#5
Full Member
Thread Starter
Join Date: Mar 2002
Location: California
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Well, it has to get smogged again about that time so It might be worth it. What about a partial (just doing the secondaries right?) how long would that last?
Trending Topics
#9
WTF!!!! 12k??? how the hell is doing your bridge port? If you leeve a good amount for the corner seal and not do a extended port and a bridge. and also do the 45deg cut you could get 50K out of it. and who needs it anymore than that??
#10
Eats, Sleeps, Dreams Rotary
iTrader: (61)
yeah 50k I can see that if you make a wuss BP. if your going to do it go all out or stay at home....
why not make a drill port instead of milling out the bridge part just drill like 3 or 4 holes it will give a little extra power. but then again it would a wuss port
why not make a drill port instead of milling out the bridge part just drill like 3 or 4 holes it will give a little extra power. but then again it would a wuss port
#11
Full Member
Thread Starter
Join Date: Mar 2002
Location: California
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
I'm going for a full on bridge, no wuss. But amemiya's idea of 45 degree angle and not to close to seal is a good one. 50k is what I'm looking for. That sounds like it will get me into college!
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM