bridge port?
10-30-07, 05:38 AM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2003
Location: Ohio
Posts: 358
Likes: 0
Received 0 Likes
on
0 Posts
bridge port?
if i do a bridge is it true a need to flop arounds the rear housing apex seals so that the little triangler piece is not on the bridge port side so it dont fall out? Or do i need to use one piece seals? Thanks
10-30-07, 08:44 AM
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 110 Likes
on
93 Posts
Generally you position the corner piece away from the eyebrow port to eliminate the chance of it catching.
On a full bridge, you run one piece seals to eliminate this problem entirely. Though it is possible to use the two piece if the cuts aren't extreme.
On a full bridge, you run one piece seals to eliminate this problem entirely. Though it is possible to use the two piece if the cuts aren't extreme.
Thread
Thread Starter
Forum
Replies
Last Post
danielbradley2
3rd Generation Specific (1993-2002)
11
09-28-15 10:44 PM
scissorhands
New Member RX-7 Technical
0
09-16-15 01:25 PM