Boost guage/controller/PS/BOV - hook up?
#1
Passing life by
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Boost guage/controller/PS/BOV - hook up?
Trying to get this VAC roughting straight. S4 TII stock turbo. I am using a manul boost controller and stock Presure Sensor with a greddy type RS BOV. What is the proper roughting? I know PS goes to the UIM VAC nipple. I know the Boost controoler goes on the waste gate line pluged int o the side of the boost controller. Where does the other side of the boost controler go? What do I do with the VAC nipple coming from the compressor housing that used to go to the waste gate? and What line do I T the BOV into? I allso have the Boost guage T'ed to the VAC line from the PS to UIM
#2
Super Raterhater
![](/images/misc/20_year_icon.png)
iTrader: (6)
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,629
Likes: 0
Received 2 Likes
on
2 Posts
MBC Goes like this: Compressor housing -> MBC -> Wastegate actuator
PS & BOV: UIM nipple -> T -> PS & BOV
Boost Gauge: T it into one of the nipples (or if they're just plugged) on the TB (find one that's routed to after the throttle plates)
PS & BOV: UIM nipple -> T -> PS & BOV
Boost Gauge: T it into one of the nipples (or if they're just plugged) on the TB (find one that's routed to after the throttle plates)
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM