Beeping when the engine is on (same as the "remove key" beep)
#1
Rotary Freak
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Beeping when the engine is on (same as the "remove key" beep)
No problems earlier today on the new rebuild, ate dinner, came back out, and it beeps at me when the key is on. It's the same beep pattern as when the key is in the ignition and the door is open, but it happens when the key is fully on, regardless of the door being open or closed. It works properly with the key in the "off" position and the door, though.
Ideas?
-=Russ=-
Ideas?
-=Russ=-
#2
Rotary Freak
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
*turns red*
Figured it out.
While I was cleaning the car, I reconnected a goofy little connector going to the seat belt. Turns out that the beeping was the "buckle up, idiot!" alarm.
It's disconnected again. (I do buckle up, but I don't want the car beeping at me while I'm working on it or letting it warm up)
-=Russ=-
Figured it out.
While I was cleaning the car, I reconnected a goofy little connector going to the seat belt. Turns out that the beeping was the "buckle up, idiot!" alarm.
It's disconnected again. (I do buckle up, but I don't want the car beeping at me while I'm working on it or letting it warm up)
-=Russ=-
#4
Rotary Freak
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
If you slide the driver's seat all the way forward, there's a flap on the center console right near the end of the seatbelt stalk. There's a connection that goes from the end of the stalk into the floor area - there's a removable connector. Disconnect it.
-=Russ=-
-=Russ=-
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
KAL797
Test Area 51
0
08-11-15 03:47 PM