Anyone ever order RWS (Rotary Aviation) engine kit? I have a ? about it
09-15-04, 05:02 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2001
Location: lancaster pennsylvania
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Anyone ever order RWS (Rotary Aviation) engine kit? I have a ? about it
If you ever ordered their internal engine kit (preferably for an 86-88 turbo) I have a question. Which o-ring did you use at the oil cross over point between the front housing and front cover? The only one that is close to working is very thick and prodrudes rather high out of its seat. Can any of you relate to this senerio? I have been emailing RWS and havn't had a response yet. Thanks for your input.
09-15-04, 06:04 PM
#2
Rotary Enthusiast
Join Date: Oct 2002
Location: California, Bay Area
Posts: 1,165
Likes: 0
Received 0 Likes
on
0 Posts
Its a little thin o-riing in a packed labled "Front Cover O-ring) it is to be used without a front cover gasket or teflon ring. In my kit it was packed seperatly from all the other o-rings.
09-15-04, 06:43 PM
#3
Senior Member
Thread Starter
Join Date: Dec 2001
Location: lancaster pennsylvania
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Well, I definitely didn't have an o-ring that was labeled like that, so perhaps I am missing it. The only one I found that was close (to be used by itself) was in a pack that included an identical o-ring along with the oil-metering pump o-ring.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM