89 N/A turbo
#53
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,791
Likes: 0
Received 114 Likes
on
96 Posts
Remember: a boost controller cannot lower boost, only raise it.
I ran 12 PSI at times without issues, but I was well out of fuel at that point. If the air temp had been low, there would have been detonation.
I ran 12 PSI at times without issues, but I was well out of fuel at that point. If the air temp had been low, there would have been detonation.
#57
Super Raterhater
iTrader: (6)
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,630
Likes: 0
Received 3 Likes
on
3 Posts
It depends on what fuel setup you're using really, I'm running a BNR stage 3 on my stock port (6port n/a) at 18psi without problems with two 720s and two 1000cc's, i've got quite a bit of room to work with though.
Oh, and also, a stock turbo will boost to ~6psi before the wastegate opens, which basically means that's the lowest you can go. You can port the wastegate so it doesn't creep up past that, but a boost controller will only raise it from 6.
Oh, and also, a stock turbo will boost to ~6psi before the wastegate opens, which basically means that's the lowest you can go. You can port the wastegate so it doesn't creep up past that, but a boost controller will only raise it from 6.
#59
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,791
Likes: 0
Received 114 Likes
on
96 Posts
Originally Posted by smoke wagon
i dont know what boost numbers it will make. the engine is got about 8000 miles on it and its street ported. you also said 12psi is that after your bridge port or before?
#70
Is that thing Turbo?
Join Date: Jan 2004
Location: Maryland
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
you know anything more specific than just from a lincoln? possible model and year? It looks like the shroud fits perfect
Ohh yeah and great job my turbo 6 port project will start as soon as i locate a tii tranny and rear, hope it turns out like yours did looks great
Ohh yeah and great job my turbo 6 port project will start as soon as i locate a tii tranny and rear, hope it turns out like yours did looks great
#74
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,791
Likes: 0
Received 114 Likes
on
96 Posts
TPS should be set to 1K. Did you disconnect your coolant tube at the throttle body? If so, then the cold start cam will be holding the engine speed up. Also, it goes without saying to check for any vacuum leaks. Throttle cable too tight?