86 won't idle in gear after banjo bolt mod
#1
Newbie
Thread Starter
Join Date: May 2008
Location: northeast pa
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
86 won't idle in gear after banjo bolt mod
Does anyone know where I can get a code reader for my 86 rx7 n/a? I bought the car with the fuel leak. I installed the banjo bolt. I took the car for a ride and it had no power. alot of hesitation. In neutral it revs fine, but under load it has a pronounced hesitation. It has also developed a vibration. It came on in the garage, all of the sudden. not terrible, but there. It compression tested 85-90 on both cylinders with compression tester check valve removed. both cylinders give 3 good pulses. Since the vibration it will not idle in gear. Seems to start and idle fine in park. Keep in mind I bought this car with a fuel leak on e-bay, so I never drove it. I ran it to put it on the trailer. It started well and revved good. But it was not run under load. I am new to the rotary thing. I bought the car for for my son. I am very interested in the technology, but not very proficient. Any help you guys could give to this mopar musclecar guy would be greatly appreciated.
Thanks, Former boinger, Current rotary addict
Thanks, Former boinger, Current rotary addict
![Wallbash](https://www.rx7club.com/images/smilies/wallbash.gif)
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM