86 N/A to TII conversion
05-10-05, 01:39 AM
#1
Full Member
Thread Starter
Join Date: Apr 2004
Location: Ottawa, Ontario
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
86 N/A to TII conversion
I am about to purchase a TII motor with tranny from a place in Montreal, its called Osaka.
I jsut wondering what I should be looking out for when I do this install. I know that I have to purchase the TII driveshaft, rear end and also the half shafts which I will. I just need some help looking for these parts. The TII will obviously be coming out of an 87-91 rex. Its a j-spec motor. I was also wondering if anyone has done this and time wise it took and how much it cost them for the whole system ecluding the motor and tranny. LIke ecu wiring, drive line, etc. I am going to be doing this for sure, becuase its either I rebuild my motor so that my coolant/overheating problem is gone or I replace, so I want to put a TII with all driveline in an 86 GX.
Thank You for the help
Take it easy.
Nick
I jsut wondering what I should be looking out for when I do this install. I know that I have to purchase the TII driveshaft, rear end and also the half shafts which I will. I just need some help looking for these parts. The TII will obviously be coming out of an 87-91 rex. Its a j-spec motor. I was also wondering if anyone has done this and time wise it took and how much it cost them for the whole system ecluding the motor and tranny. LIke ecu wiring, drive line, etc. I am going to be doing this for sure, becuase its either I rebuild my motor so that my coolant/overheating problem is gone or I replace, so I want to put a TII with all driveline in an 86 GX.
Thank You for the help
Take it easy.
Nick
Thread
Thread Starter
Forum
Replies
Last Post
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM