ok heres the deal i did my timing and tps adjustments last night,drove a couple places..it started fine,but this morning it wont even turno over like its getting no spark...i have swapped out coils,put a new fuel filter in,checked all fuses,swapped out the crank angle sensor,cleaned the plugs wich were saturated in fuel...installed a fuel cut switch...put a new o2 sensor in...and the damned thing still wont fire??? any suggestions this is killing me....ive tried damn near everything i can think of.....thanks jr

 

ps i swapped out the leading coil

 

wont turn over? like the engine wont turn over at all? or just wont fire?

 

If it wont turn over, start with the battery and then the battery cables, and so on.

 

sorry,wont fire.....i took out my walbro and the sock was dirty as ****,put the stock sock on the walbro now it almost fires..goes to like 400 rpm then dies back out....and this is with a fuel cut switch.....almost got it but not quite....and my coils are firing....

 

Was the sock intact? Even a small hole can allow debris to plug the main fuel filter.

 

yes the sock was intact and i replaced the main fuel filter also