So, while I'm saving for my rebuild, porting irons, bonding hammer dents, etc, etc, etc. I figure I'll probably re-do my whole wiring harness. My factory wiring harness is redneck/hillbilly spliced and cut, and I removed/blocked off all the emissions. As well as chipping the ecu to do away with the pesky s5 MOP limp modes.

Enough about myself, I figured somebody has some pictures of their custom wiring harness so lets see them!?!?!??!?!?!?!?!
Thank you.

 

I don't have an FC harness, but here is my custom tucked harness from my dsm.

I used a flex braid kit I found on amazon for 35$ but next time I will be ordering my own stuff. I would rather use F6 braided sleeving from wirecare.com. Its split so you need not de pin connectors to snake the wires through.

 

Depending what you are going to run, you can remove quite a bit. You can end up with a very clean wiring harness.

I'll be going this route, but I'll be using almost nothing from the original wiring.

 

isis mutli system for the win