Wiring Issue?
#1
Stocker12A
Thread Starter
Join Date: Apr 2012
Location: North Bay, ON, Canada
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
I am trying to figure out how this wiring is supposed to go back together. I have looked through both the Haynes manual and the FSM for the year.
I cant seem to find what plugs are in the loom. The two connectors are:
The temp sensor in the back of the water pump. Two wires, male connector with female leads.
And the richer solenoid on the carb. Two wires, female connector with male leads
I cant seem to find what plugs are in the loom. The two connectors are:
The temp sensor in the back of the water pump. Two wires, male connector with female leads.
And the richer solenoid on the carb. Two wires, female connector with male leads
Last edited by JMoneyLSB; 04-12-15 at 01:34 PM.
#2
Stocker12A
Thread Starter
Join Date: Apr 2012
Location: North Bay, ON, Canada
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
I have the richer solenoid wiring figured out.
Now i just need to figure out the wiring for the temp sensor... Is the plug located in the same section of loom as the alternator or the same section as the acv?
Now i just need to figure out the wiring for the temp sensor... Is the plug located in the same section of loom as the alternator or the same section as the acv?
#4
Stocker12A
Thread Starter
Join Date: Apr 2012
Location: North Bay, ON, Canada
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
There is a bunching of wires from the ACV, a bunching that connects to the carb as well as the alternator, and a bunching that connects the solenoids for the ratsnest...
I think it belongs to the bunch for the alternator, is that correct?
I think it belongs to the bunch for the alternator, is that correct?
#5
Out In the Barn
iTrader: (9)
For a 1985, on page B2 of the wiring diagram (85RX7(50)Wiring_Diagrams.pdf on foxed.ca), it's connector is B17. It shows the wire traces back to the E.G.I & Emissions Control Unit at pin "C". The wires for the EGI unit run through the firewall on the passenger side.
The believe the furthest connector in the the dizzy/alternator bungle is the alt 2 pin connector.
The believe the furthest connector in the the dizzy/alternator bungle is the alt 2 pin connector.
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM