Water Temp Sender
12-11-01, 08:47 PM
#1
Junior Member
Thread Starter
Join Date: Dec 2001
Location: Hadley, MA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Water Temp Sender
Can anyone tell me how to replace my water temp sender? My water temp gauge always reads just above "C". I've replace the thermostat but no change. I am getting plenty of heat and the choke goes in as normal. I'm hoping it's the sender and not the gauge. My 3 Mazda manuals don't specifically indicate where the sender is and how to change it.
RX-7 Restoration Project
RX-7 Restoration Project
12-11-01, 09:05 PM
#2
The AUTO DOCTOR
Join Date: Mar 2001
Location: South Side of ATL. Ga.
Posts: 1,952
Likes: 0
Received 0 Likes
on
0 Posts
well you have 2 temp senders. 1 in the waterpump thermo area... its a big sender. the other is in the rear plate, right by the oil pressure sender. the water temp is the SMALL unit. watch out the plug likes to break off when you are removing it so be careful.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM