volumetric efficiency tables - speed density metering project
12-23-04 | 02:02 AM
#1
volumetric efficiency tables - speed density metering project
Does anybody have the volumetric efficiency tables for the 12A engine?
I'm planning on converting to fuel injection and I was going to use a speed density metering system.
I'm planning on converting to fuel injection and I was going to use a speed density metering system.
12-23-04 | 11:38 AM
#2
Full Member
Joined: Jan 2002
Posts: 210
Likes: 0
From: Illinois
check this site it may have what your looking for.
i hope it helps.
http://www.megasquirt.info/manual/rotary.htm
i hope it helps.
http://www.megasquirt.info/manual/rotary.htm
12-23-04 | 11:41 AM
#3
Full Member
Joined: Jan 2002
Posts: 210
Likes: 0
From: Illinois
here is another thread that talks about speed density
https://www.rx7club.com/microtech-111/speed-density-throttle-possition-146775/
https://www.rx7club.com/microtech-111/speed-density-throttle-possition-146775/
12-23-04 | 11:53 AM
#4
Senior Member
Joined: Apr 2003
Posts: 427
Likes: 0
From: UK
Yark! there is some misinformation out there...
VE is very close to torque, get a torque curve for your engine and then base the WOT VE on that. There is a program on the MS site that automagically calculates a table for you based on the torque curve.
VE is very close to torque, get a torque curve for your engine and then base the WOT VE on that. There is a program on the MS site that automagically calculates a table for you based on the torque curve.
Thread
Thread Starter
Forum
Replies
Last Post
