Temp and Oil pressure guages not working
01-02-06, 12:23 PM
#1
Full Member
Thread Starter
Join Date: Oct 2005
Location: NY
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
Temp and Oil pressure guages not working
Where are the temp and oil pressure connections? when my bro put in the 12a he never connected them. I would look in my haynes book but i cant find it
01-02-06, 01:41 PM
#2
FB+FC=F-ME
Both are just below the oil filter, on the rear housing.
The oil pressure is the large canister coming straight out of the side of the engine.
The water temp is the smaller sensor thats a little forward of the oil sender.It comes out of the block a little diagonal.They each have different plugs so you cant mix them up......
The oil pressure is the large canister coming straight out of the side of the engine.
The water temp is the smaller sensor thats a little forward of the oil sender.It comes out of the block a little diagonal.They each have different plugs so you cant mix them up......
01-02-06, 01:41 PM
#3
Rotary Freak
Join Date: Jun 2003
Location: Land Of Confusion southern MI, USA
Posts: 2,604
Likes: 0
Received 1 Like
on
1 Post
coolant is under where the oil filter is, on the side of the housings. it sticks out just a little. its really hard to reach/see
yea listen to him^^^^^he knows his ****, and obviously kows alittle more clearer than me.
yea listen to him^^^^^he knows his ****, and obviously kows alittle more clearer than me.
Last edited by perfect_circle; 01-02-06 at 01:45 PM. Reason: not done
Thread
Thread Starter
Forum
Replies
Last Post