Someone with a stock fan setup & stock alternator pulley, can you measure the distance from the inside of the alternator pulley bolt, to the inside of the fan blades? I'm working on a strut bar design and need a clearance measurement. I need a conservative measurement. I attached a picture to try and make it a little clearer.

Thanks guys!
Jamie

 

That'd be 3 inches or 7.5 cm Jamie.

Ray

 

Thanks Ray! Can someone else confirm that for me, just to be sure? (Not that I don't trust you Ray, just want to make sure that it is the same on a couple of different vehicles.

 

i'll go out and measure it on my SA today for ya