SA or FB Fenders?
01-13-10, 02:30 AM
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Pennsylvania
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
SA or FB Fenders?
So I have these fenders and my understanding was that SA's and FB's had different fenders because of the different bumper designs. Is this true and which kind are these?
01-13-10, 12:56 PM
#2
Full Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Pennsylvania
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
I'll try another host, but I will post these fenders in the forsale section once I know whether these are for an SA or an FB. Original Mazda fenders that were in my friends garage for the past 20 some years.
01-13-10, 05:54 PM
#3
Full Member
Join Date: Jul 2007
Location: Tokyo
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
those look like mine, so I'm gonna say FB. Might want to check that the bolt patterns are the same too. I'm gonna run out and check my car...
I've got four on top and two on the bottom by the door, as well as the ones that connect to the center top piece and the faring underneath. look around for some build threads of SA's since there tend to be pictures with the bumper off, just to make sure those openings on the front of your fenders match up...
I've got four on top and two on the bottom by the door, as well as the ones that connect to the center top piece and the faring underneath. look around for some build threads of SA's since there tend to be pictures with the bumper off, just to make sure those openings on the front of your fenders match up...
Last edited by takhay; 01-13-10 at 06:02 PM. Reason: went to check the car...
01-16-10, 12:45 PM
#6
Senior Member
Join Date: Apr 2006
Location: spokane, wa
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
yes, i can tell I have a sa I am working on, you can tell the difference by the front bumper opening. its molded to let the rubber end caps (that are impossible to find) sit flush with the metal fender.
