S5 turbo swap to a GSL_SE
#1
Full Member
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Join Date: Nov 2003
Location: NM
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
![Question](https://www.rx7club.com/images/icons/icon5.gif)
Ok I have a 1992 S5 turbo II engine in a 1987 S4 chassis. I had to have a drive shaft made for this application. What I need to know if anyone knows if I swap this engine into my GSL-SE. Will the drive shaft work still work?
#2
Soft & Wooly
Join Date: Jan 2007
Location: Lakewood, CO (formerly Seattle)
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
ahhh. I guess the drive shaft you had made was for turbo transmission to NA rear end? In that case no it won't work in a GSL-SE, it is the wrong length.
#4
FB+FC=F-ME
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Ditto....
I used a turned down, TII rearend yoke on my SE axle.Then had a shaft made to match the TII trans splines and yoke,but the 1st gen distance.Greasable replaceable Ujoints, roughly Mustang sized......... 'Bout 200 bucks.
I used a turned down, TII rearend yoke on my SE axle.Then had a shaft made to match the TII trans splines and yoke,but the 1st gen distance.Greasable replaceable Ujoints, roughly Mustang sized......... 'Bout 200 bucks.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM