Replacing the radio & EQ
#1
Replacing the radio & EQ
I'm going the replace the radio and EQ on my lastest SE with some stock units that aren't so trashed out. A few q's:
Thx!
- How do you get at the audio gear? Do you have to pull the dash or anything crazy like that?
- Anyone know of some working stock units for sale?
Thx!
#4
Banned. I got OWNED!!!
iTrader: (2)
to remove the radio and equalizer all you have to do it take off the grey bezel, and the 2 side corner plastics on both sides of the bezel and there should be 4 screws (i think thats about right ) that hold each unit. Also if you want to take the rest of the surround sound off, there should be 2 amplifiers under each compartment bins, most of the wiring runs from the driver side door under the carpet, there should also be some running to the console
#5
JDGJr
Join Date: Aug 2004
Location: 7400 ft plus jack stands
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
If noone has removed the grey bezel before, the nuts for the heater controls will be holding it on. Just remove the bezel around the shifter, the 2 screws at the bottom of the upright bezel, the heater ***** and nuts (there are wires to the lights behind the *****). then the 4 screws around the stereo bracket and pull it out. Wires from the harness to the unit are realy short.
Trending Topics
#8
JDGJr85GSLSE is correct. Did that to change mine out with an aftermarket cd player and it went smoothly.
I have 2 sets of stock amps, a stock radio and EQ, and 2 sets of stock speakers (mostly working). If you want anything lemme know via PM.
I have 2 sets of stock amps, a stock radio and EQ, and 2 sets of stock speakers (mostly working). If you want anything lemme know via PM.
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM