Race Car For Sale
#1
Junior Member
Thread Starter
Join Date: Oct 2002
Location: Norman, OK
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Race Car For Sale
We have several cars, and are forced to make some room. So here is your chance to own the nicest first gen car I’ve ever seen. Paint and interior are show quality. We’ve owned this car for several years and built it from the ground up. No expense spared, the best of everything. All fabrication is top notch. Fast….Low 14’s in the quarter mile and a potentially nationally competitive autocross/road race car in the right hands. Asking $6900 will consider trades. Serious inquiries only please. Chris Andersen 405-422-4400. Thanks…Details below….Many more photos available
1985 Mazda RX-7 GSL-SE
6 Port 13b with strong compression
Dellorto Side Draft carb with custom aluminum airbox and direct ram air duct
Atkins Aviation intake manifold
Perma cool oversized oil cooler with aeroquip lines
Perma Cool oversized cooling fan
Mazda comp dual underdrive aluminum pulleys
Direct ignition...2 MSD 6A-L Boxes with 3 blaster 3 coils
MSD 9mm Plug wires
Mazda comp engine mounts
Custom torque brace
Relocated Battery with cut off switch
Racing beat header (HPC Coated)
Racing beat pre-silencer (HPC Coated)
Custom aluminum heat shielding in engine compartment
2 1/2" exaust tubing with stainless steel Edelbrock Ceramic Muffler
Mazda Comp type 1 Torsen Limited Slip Differential
5:12 rear end gear
Full compliment of Autometer liquid filled gauges in custom aluminum dash pod
Autometer oversized tach
Kirkey deluxe seats (2)
5 point harnesses (2)
Momo Monte Carlo steering wheel
Momo Shift **** with leather boot
Kosei K-1 Racing 15x7" wheels with Hoosier tires
Racing beat coil over kits with camber plates
Tokico Illumina Shocks
Eibach Springs
G-Force Tri-Link Rear suspension with panhard rod
Custom built infinately adjustable sway bars front and rear
All suspension bushings are new (suspension techniques)
New ball joints and tie rods and wheel bearings
New rotors with Hawk Brake pads, (2 sets)
Mazda comp braided steel brake lines
Tilton Proportioning valve
Custom Strut tower brace
Centerforce Clutch
Mazda Comp 9 lb aluminum flywheel
Autopower rollcage available, but not installed. (would be additional $$$)
All original Fuel injection parts available.
And a few other things I'm sure I've forgotten.
http://www.especialtycars.com/rx71.JPG
http://www.especialtycars.com/rx72.JPG
http://www.especialtycars.com/rx73.JPG
http://www.especialtycars.com/rx74.JPG
http://www.especialtycars.com/rx75.JPG
1985 Mazda RX-7 GSL-SE
6 Port 13b with strong compression
Dellorto Side Draft carb with custom aluminum airbox and direct ram air duct
Atkins Aviation intake manifold
Perma cool oversized oil cooler with aeroquip lines
Perma Cool oversized cooling fan
Mazda comp dual underdrive aluminum pulleys
Direct ignition...2 MSD 6A-L Boxes with 3 blaster 3 coils
MSD 9mm Plug wires
Mazda comp engine mounts
Custom torque brace
Relocated Battery with cut off switch
Racing beat header (HPC Coated)
Racing beat pre-silencer (HPC Coated)
Custom aluminum heat shielding in engine compartment
2 1/2" exaust tubing with stainless steel Edelbrock Ceramic Muffler
Mazda Comp type 1 Torsen Limited Slip Differential
5:12 rear end gear
Full compliment of Autometer liquid filled gauges in custom aluminum dash pod
Autometer oversized tach
Kirkey deluxe seats (2)
5 point harnesses (2)
Momo Monte Carlo steering wheel
Momo Shift **** with leather boot
Kosei K-1 Racing 15x7" wheels with Hoosier tires
Racing beat coil over kits with camber plates
Tokico Illumina Shocks
Eibach Springs
G-Force Tri-Link Rear suspension with panhard rod
Custom built infinately adjustable sway bars front and rear
All suspension bushings are new (suspension techniques)
New ball joints and tie rods and wheel bearings
New rotors with Hawk Brake pads, (2 sets)
Mazda comp braided steel brake lines
Tilton Proportioning valve
Custom Strut tower brace
Centerforce Clutch
Mazda Comp 9 lb aluminum flywheel
Autopower rollcage available, but not installed. (would be additional $$$)
All original Fuel injection parts available.
And a few other things I'm sure I've forgotten.
http://www.especialtycars.com/rx71.JPG
http://www.especialtycars.com/rx72.JPG
http://www.especialtycars.com/rx73.JPG
http://www.especialtycars.com/rx74.JPG
http://www.especialtycars.com/rx75.JPG
#2
Off riding sportbikes!
Join Date: Aug 2002
Location: Vancouver Wa
Posts: 1,154
Likes: 0
Received 0 Likes
on
0 Posts
Man why didnt you put this up for sale 2 months ago?!!? thats exactually whaty I was looking for. Damnit.
DOnt have the cash now. Would love to have it. Good luck, looks like a great car.
DOnt have the cash now. Would love to have it. Good luck, looks like a great car.
Thread
Thread Starter
Forum
Replies
Last Post