Jeezus

iTrader: (4)

I hear that duct tape around the porting guide will help if a drill bit goes crazy on you and not scar the irons/housings. I can get all the carbide bits I need for free, so I don't have to go through RB unless I get the porting templates.

Also, can an El Cheapo electric dremel tool do the job or am I stuck with buying an air power tool?

Any advice would be great. These are going on some housings I have lying around.

teddyrx2

iTrader: (33)

I use both air tools and dremel tools to get the job done on both my irons and housings...

The are two different set of housing's the first three are turbo II housings

The first two is one that is done and the other is not done


Another is done

and one that is almost done...

broke7

iTrader: (1)

make sure your bits are for the right type of metal (iron or alum). you can use a dermel but it will take longer