FB II

i have an npr intercooler... the short yet very wide one.... how could i mount this fugger??? i pulled the radiator out of the way but damn, this is a wide *** intercooler. anyone have this particular one setup? if so gimme pics pleeaaaase! direct freak which one do you have?

-zac

Eville140

He has the big one, as do I. they are the same width as yours but just with a few more rows of tubes on the bottom.
I have mine mounted right in front fo the radiator. The inlets and outlets are just wide enough to get around the stock radiator with a little bit of trimming on the radiator side mounts. Fit almost to good really.
I know you guys might not like it, but here engine shot of my rx7. You can see wher the inlet and out tubes are.


Later
Randy

FB II

soo, what did you attatch it to??? haha, yea i did notice there be a bit of trimming needed. looks like you bolted it to the radiator or something! hahaha, did you? nice. i appreciate your help! right now it's just sitting at an angle with a zip tie or something.

Eville140

I welded in a piece .5" angle iron that runs from left to right that goes under the intercooler. Then the bottom two mounting ears on the intercooler bolt to it. The top fits tight enough that I didn't need anything. It has been in there for a cuple years now and it is working great.

Later
Randy

Directfreak

iTrader: (2)

Nice Randy!

Did you mount it where the A/C condenser normally goes?