the car is an 83 gsl with a tii swap and the leading ignition is a dlisdf run off an msd 6al with two blaster coils and the trailing is run off a stock coil and through the dizzy
it was running fine and firing yesterday i went though and rewired alot of the car today because the battery was relocated and poorly wired also had alot of wires running all over the place under the dash but i hooked all the wires back up to the 6al box the way it was and have power and ground going in to the box also have power on the ignition power wire but im not getting any power out to the blaster coils i dunno what else to look for i bought the car already wired up and am working though all the problems but i can't figure out why the coils are not fireing now if it is still wired up the same way any advice would be helpful thanks

 

Instructions are available on the MSD site. This is the diagram for use with the magnetic pickup (no leading ignitor).
http://www.msdignition.com/instructi....pdf?terms=6al

 

Yeah I found that but I didn't mess with the wries to the dizzy but I went and checked them and they were a little lose all good now thanks for the input