Need Rebuild/new engine advise(a.s.a.p.)
#26
Junior Member
Thread Starter
...
How much oil are you loosing? Unless you can watch the oil run out of the engine just standing there, you might try running a quart of Lucas Heavy Duty Oil Stabilizer in place of one quart of motor oil. The stuff does wonders, and doesn't contain any sort of block sealant or anything else that might cause problems.
AS of right now she has a freash oil change so how long should I wait to use the Lucas? and how much? will the hole quart be to much? or should I just get another oil change and use 1 quart Lucas?
#28
Junior Member
Thread Starter
control arm question
ok so I am going to replace the control arm, is there any other misc peices I should also replace at the same time? The suspension place was vaig and I though you guys chould help let me in advance so I dont have to buy bushings ext. later
#31
Lives on the Forum
If you're bleeding at the rate it sounds like you are, just wait until you are a quart or two low, then top it off with the Lucas. This is not a cure, more of a way of accommodating a problem. But it might get you by until you are ready for a rebuild....
#32
Junior Member
Thread Starter
...
Thank you guys for your help, I have decided to park her for now, I have decided that I need to either buy a new car and use my rx7 as a project car or sell/trade my seven for a newer year to mod. But If I do keep and rebuild where should I buy the rebuild kit from?
thx, anthony
thx, anthony
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM