blown7

So i have been working on making my housings a little more appealling to the eye. I have one done so far and one to go. Just thought i would share a few pics side by side.

blwfly

iTrader: (4)

care to share how that was done?
looks very appealing

blown7

I bought one 4" wheel and one 3" wheel, both were fine brass wire wheels. The wheels came with arbers that slide into the chuck of a drill. From there i just went to town on the housing making sure not to put too much pressure on the housing. I getting some hi temp clear coat from wurth to protect the housings from corrosion.

blwfly

iTrader: (4)

nice i used steal wire wheel and didnt turn out as clean good job matey.

Ricky74

that looks good...
whenever I decide to open up the engine I will look into that.. as for now.. it will remain stock...

85rotarypower

You must use a brass wire wheel on aluminum housings otherwise you could end up putting some niced sized pits in the aluminum from a steel or stainless steel wire wheel. The steel is harder than aluminum and with really wear it down fast.

H4Inf

absolutely beautiful. brass it is then