Mechanical Water Temp
05-03-08, 08:28 AM
#27
Boosted Fb
iTrader: (1)
Join Date: Nov 2003
Location: Lost!
Posts: 1,471
Likes: 0
Received 0 Likes
on
0 Posts
My stand alone uses standard GM sensors which are 3/8 npt so the hole for the stock sensor was too small. Anyways I guess it depends on what youre using it for. Like I mentioned before when I had this on the upper hose my cold start,warm up would take forever. Hope this helps.
Ed
Ed
05-03-08, 11:26 PM
#28
Rotary Enthusiast
Thread Starter
I couldnt find a temp sensor to fit the stock pump!
Im not sure if mine is a 12a housing or a gslse housing though.
I made an adapter out of the stock sensor that was allready there.
Ill take some pics tomarrow for yah.
Im not sure if mine is a 12a housing or a gslse housing though.
I made an adapter out of the stock sensor that was allready there.
Ill take some pics tomarrow for yah.
05-04-08, 03:15 PM
#29
Rotary Enthusiast
Thread Starter
http://70.89.145.60/rice/5-4-08-8.jpg this one is the homeade adatper
http://70.89.145.60/rice/5-4-08-9.jpg This the spiced in water temp port
the pics are LARGE!!
http://70.89.145.60/rice/5-4-08-9.jpg This the spiced in water temp port
the pics are LARGE!!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM