I think I f'ed up!
#1
Hunting Skylines
Thread Starter
Join Date: Apr 2001
Location: Brisbane, Queensland, Australia.
Posts: 3,431
Likes: 0
Received 3 Likes
on
3 Posts
I think I f'ed up!
I was just under the bonnet checking the oil and whatnot when I noticed a small oil leak coming from the OMP block off plate (I run pre-mix). Anyway, I went to check if the bolts were tight and before I put barely any pressure on it one of the bolts snapped. I've gotta fucken stop doing that! I seem to have a bad habit of cranking on bolts and **** too hard. Anyway, it doesn't look like I can get a drill in there unless I take the water pump out because the water pump neck's right in the way. Is there any other way to get this ***** out? Anyone?