HELP! Real quick question about the axles.
10-13-06, 03:21 PM
#1
1st gens only
Thread Starter
iTrader: (6)
Join Date: Oct 2002
Location: Ormond Beach, FL
Posts: 1,125
Likes: 0
Received 0 Likes
on
0 Posts
HELP! Real quick question about the axles.
Hey guys,
I am replacing the 3rd member on my GSL-SE this afternoon. Everything went smoothly until I went to put the axles back it.
They will not go back in, I have them in the slots and started hitting them back in. Ive gone from a rubber mallet to a small sledge hammer. And the outter seals/bearings whatever you want to call them are still almost half and inch out on either side.
Is that how they seat? I cant remember, and am trying to get this done tonight.
Thanks in advance for the help.
-Greg
I am replacing the 3rd member on my GSL-SE this afternoon. Everything went smoothly until I went to put the axles back it.
They will not go back in, I have them in the slots and started hitting them back in. Ive gone from a rubber mallet to a small sledge hammer. And the outter seals/bearings whatever you want to call them are still almost half and inch out on either side.
Is that how they seat? I cant remember, and am trying to get this done tonight.
Thanks in advance for the help.
-Greg
10-13-06, 05:55 PM
#3
1st gens only
Thread Starter
iTrader: (6)
Join Date: Oct 2002
Location: Ormond Beach, FL
Posts: 1,125
Likes: 0
Received 0 Likes
on
0 Posts
I just figured out that all I really needed was the rubber mallet.
Oh well, I hadnt changed one in more than 5 years.
Thanks for the help!
-Greg
Oh well, I hadnt changed one in more than 5 years.
Thanks for the help!
-Greg
Thread
Thread Starter
Forum
Replies
Last Post
