help me figure this out please, i'm having trouble with fuel deliver
#1
Newbie
Thread Starter
Join Date: Aug 2006
Location: Fultondale Al.
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
help me figure this out please, i'm having trouble with fuel deliver
i have a 1979 rx-7 and when i run it up in rpms in any gear it wants to act like it is running out of gas it will do it 4 a while and then run fine, but i have replaced the fuel fillter and the fuel pump, i just dont know what is wrong with it it runs fine 4 about 30 minutes and the it will act up so will some one please help me figuer this out
#3
Full Member
Join Date: May 2006
Location: Statesville, NC
Posts: 244
Likes: 0
Received 0 Likes
on
0 Posts
My '83 had been sitting for 13 years. After doing a lot of fluid changing and maintenance, etc., I got it running. It ran fine for about 60-70 miles and then started symptoms as you described above. I changed fuel filters a couple of times and then the fuel pump. Fuel pressure coming out of the line at the carb was like an old man with prostate cancer peeing. Turned out that the fuel tank was full of varnish and rust. I got it boiled out at a radiator shop and it runs fine now (other than some flooding due to air vent solenoud problem).
- David
- David
#4
Newbie
Thread Starter
Join Date: Aug 2006
Location: Fultondale Al.
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I have a brand new gas tank under it and it still acts up. It will spudder like it is not getting gas and i dont know whats wrong with it. The floats have been adjusted to the right level and we cleaned the carborator and its still having problems.
#5
Lorem ipsum dolor sit ame
God damn that's a tough one. So it's not the tank, it's not the filter, it's not the pump or the carburator. But it's a fuel problem. And it's a '79 so my favorite question about trailing ignition won't work here.
Can I buy a bowel?
Can I buy a bowel?
#6
its supposed to do that
there are 2 banjo bolts on the top of the carb where the incoming fuel is directed down into the float bowls, around these bolts is a very small metal screen, undo those bolts and i will bet you the screens are clogged, i have seen this on more than one occasion and it causes the exact syptoms you describe.
isaac
isaac
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM