gaskets
#1
Junior Member
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Join Date: May 2004
Location: minnesota
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
gaskets
im about to put in some pineapple racing sleeves and i was wondering what gaskets i will need to replace and if it would be better for me to buy the actual gaskets or to just buy some instant gasket any helpful advice would be greatly apreciated
#2
I would have on hand the LIM and LIM to UIM gaskets at a minumum. The LIM to 6th port actuator gaskets you will have to make yourself. Not hard, just make sure you cut the hole in the for the exhaust backpressure in the right spot. I usually cut out the gasket material a little larger than needed, spray it with disc brake adhesive, stick it on the actuator and trim with an xacto knife.
While you're in there you might as well replace the vacuum lines.
While you're in there you might as well replace the vacuum lines.
Thread
Thread Starter
Forum
Replies
Last Post
matty
3rd Generation Specific (1993-2002)
40
10-06-15 09:13 PM