Early carbed RX-7 fuel pump install?
04-11-05 | 09:56 PM
#1
Thread Starter
Newbie
Joined: Apr 2005
Posts: 1
Likes: 0
From: Portsmouth, Va
Early carbed RX-7 fuel pump install?
I want to install a fuel pump from a late eighties carburated RX-7 into my 71 240Z. I have two of these low pressure (4psi) pumps. They have a fitting that
comes directly out of the body and another that comes out perpendicular. There are also two wire leads, one black and one black/white. Could someone tell me which fittings are in and out. Also, can someone tell me which lead is positive and negative? Thanks in advance!
comes directly out of the body and another that comes out perpendicular. There are also two wire leads, one black and one black/white. Could someone tell me which fittings are in and out. Also, can someone tell me which lead is positive and negative? Thanks in advance!
04-12-05 | 04:07 PM
#3
Rotoholic Moderookie
iTrader: (4)
Joined: May 2002
Posts: 5,962
Likes: 33
From: Ottawa, Soviet Canuckistan
IF it's a stock replacement pump then the black-with-white is positive, and black solid is ground/negative.
As for the in-out, I'm not sure but I believe that the one that comes directly out is the output.. but don't quote me on that, I'm running an aftermarket fuel pump now.
Jon
As for the in-out, I'm not sure but I believe that the one that comes directly out is the output.. but don't quote me on that, I'm running an aftermarket fuel pump now.
Jon
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 05:40 PM
