slashdawg00110

How much play (fore/aft) should the fork have? Mine wiggles back and forth, haven't measured it, but should it move at all?

I read that the release bearing should be lubed, but with what and how much?

Siraniko

iTrader: (13)

the throw out bearing or release bearing is sealed. But clean the shaft with fine grit sandpaper to remove any burrs etc etc, apply a dab of grease and slide the t/o bearing back & forth.

slashdawg00110

ok. bearing grease work alright?

Siraniko

iTrader: (13)

that should be fine and if you're using brand new clutch disc, spray the center section with brake cleaner to remove excess paint and apply small dab of grease on the input shaft. that will make trannny install easier.

blwfly

iTrader: (4)

^^^^+1 thats what doc T told me it helps

mazdaverx713b

iTrader: (91)

it does help! i just put a clutch in my camry and i used a dab of synthetic grease for the fork's ball shaped pivit point and i feel that it works quite well.

Siraniko

iTrader: (13)

Oh, I forget to mention that you need at least a 12-pack of cold heine's.